PacsOne Server

installed pacsone 5.13 with no problems. i defines 3 aetitles for the ct scan, xray and ultrasound. I can ping these with and get the proper response.However, when sending from these modalities the records are not shown in the list nor are the images stored in the short or long term archives. this h...

No, other c-echo responses are correct.

all of a sudden we are getting the message "Verify () failed=message mishmatch received=793, expected=1" while pinging a known entry in the AETitle table.

Please advise.

R. Williams

As suggested, i have set the maximum connection =1 and preferred transfer= 'JPEG lossless' to show improvement in the transfer performance of the images, but to no avail. ( i.e. a slow down of LAN performance and a number of "failed SOP instances". Question: In Auto routing, should the AETitle of th...

Thanks for the safety warning.

i can modifiy all fields in an Aetille (applentity table ) except the "preferredmTransfer Syntax" --- trying to change from "none" to "JPEG lossless"

Thanks

when i use the database and describe the applentity table all fields hase been appropriately defined. then when i "SELECT * FROM applentity;", all DICOM entries which i redefined after the upgrade are there. Again, when i try to modify "prefered syntax the change will not take place.

thanks,

I am logged in as the superuser "root". when i change preferred transfer syntax to "JPEG lossless---" and hit the modify button the value will not change.

Thanks

upon upgrading to pacsone 5.12. as you suggested , and redefind the remote diccom AeTitles, i cannot modify certain parameters ( i.e. preferfered transfer syntax).

Is this possible because we are upgranding using a trial license.

thanks

we have been running pacone server 5.1.1(extreme edition) under trial license which expires on aug 23 ,2007 )with success . Downloaded ver 5.1.2 and tried install. Followed prescribed procedures of a. stopping Apache Server, stopping Pascone server 5.12 , started install of ver 5.12. at a certain po...

we have been testing PACONE v5.1.1 (premimum) is a semi production mode over the last 30 days. our testing scenario is as follows: test hardware: --Intel p4 2.8 mhz -- 80 gig hard drive -- 1 gig ram -- intel 10/100 network interface (running 100 mhz full duplex) test software : --- MS window 2000 se...

We have been testing Pacsone server for some time now in side -by-mode with our reqular pacs server/router. Pacsone performs in a superior manner to our existing server. However , it is desirabe to modify Pacsone to modifiy the dicom header with needed elements( e.g. a site code) of images received ...