printer agfa ds5300

rjmh · Post by **rjmh** » Thu Jan 06, 2011 3:43 pm

when I print with printed ds5300 upside agfa grayscale,images printed in black

Post by **pacsone** » Thu Jan 06, 2011 4:14 pm

What are the print options you selected and was there any error logged by the Agfa printer?

rjmh · Post by **rjmh** » Fri Jan 07, 2011 5:11 am

host profile pacsone of agfa printer

Number of Copies: 1
Host Profile type: GENERIC-GENERIC (customized)
Print Priority: high
Polarity: normal
Film Orientation: portrait
Trim: no
Film Size ID:14*17
Medium Type:blue flim
Border Density (OD x100): black
Empty Image Density (OD x100):black[/img]

Post by **pacsone** » Fri Jan 07, 2011 5:13 am

These look like the Agfa printer settings. What about the print parameters you selected from PacsOne Server when printing to this printer (they are similar but not quite the same)?

rjmh · Post by **rjmh** » Sun Jan 09, 2011 10:10 pm

pacsone are the parameters of these

Orientation: Portrait
Image Display Format: Standard 2 r * 2 c
Polarity: Normal
Print Priority:MEDIUM
Print Medium: Blue Film
Film Size ID: 14-Inch x 17-Inch
Film Destination: Processor

Post by **pacsone** » Mon Jan 10, 2011 1:11 am

1. Did you check if the Agfa printer has logged any error that correspond to the print job from PacsOne?

2. You have selected the 2r x 2c display format for the output film, so how many images were you trying to print?

3. Have you tried deleting the customized printer profile for PacsOne and simply use the default profile instead?

rjmh · Post by **rjmh** » Tue Feb 01, 2011 3:41 am

use the default values of pacsone to DRYSTAR ds5300 and continue printing without grayscale

no errors on job status

Post by **pacsone** » Tue Feb 01, 2011 4:47 pm

Did you try deleting the GENERIC-GENERIC host profile configured for PacsOne on the Agfa printer, then print a sample image to see if it looks Ok? i.e., from PacsOne Server, print a sample image to Agfa as the default (no specific model defined) printer, and on Agfa no custom profile is defined for PacsOne so that all default settings are used on both ends.

rjmh · Post by **rjmh** » Tue Feb 08, 2011 3:07 am

try putting the default values pacsone and agfa printer and only print the black frame but blank image, any other advice

Post by **pacsone** » Tue Feb 08, 2011 5:02 pm

1. Did you check with the Agfa technical support on the black image?

2. Did you try printing a different modality image from PacsOne to the same Agfa printer and see if the same problem exists or not?

PacsOne Server

printer agfa ds5300

printed on drystar ds5300

imprsora not print the grayscale or does not print blank or